Bosch DS7200V2-EXP - 3.11 Test the System

DS7200V2-EXP | Installation Guide | 3. Control Panel
Programming
EN | 107
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
DACM Global Options
• Address: 3562
• Default: 0
• Selections: 0, 1, 3-5, 7
Enter This Data Digit to Select Options
DACM Global Options
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
No DACM Global Options Selected
•
Enable Arming Confirmation
•
•
•
•
Any User Confirms Arming
•
•
Use Tamper-Wired Processing
•
•
•
Reserved
This is a global parameter that affects all DACMs connected to the control panel.
• Enable Arming Confirmation: If this option is enabled, verifying a user at the DACM reader during
Exit Delay cancels the remaining Exit Delay time and arms the control panel immediately. Only the
user who started the arming process can confirm arming. If this option is disabled, verifying a user
at the DACM reader during Exit Delay cancels the arming process (the system does not arm).
• Any User Confirms Arming: If this option is enabled, any user can confirm system arming. If this
option is disabled, only the user who started the arming process can confirm arming. This option
only applies when “Enable Arming Confirmation” is selected.
• Use Tamper-Wired Processing: If this option is enabled, an open door reports as faulted (the
zone assigned to the DACM functions as a tamper-wired zone). If this option is disabled, an open
door reports as shorted (the zone assigned to the DACM functions as a single EOL zone).
3.11 Test the System
After finishing the installation and programming of the control panel, make a complete functional test
of the system. Test the control panel and all devices for proper operation. Test after you first program
the control panel and after any subsequent programming session. If you test a device and the control
panel does not respond, there might be a problem with the device, the wiring, a module setting, or
the programming for the zone.