Bosch DS7200V2-EXP - Figure 50: DX4010 P2 Jumper Pin Settings; Figure 51: RS-232 Device DIP Switch Setting; Figure 52: DB9 Connector Layout; Table 14: Dx4010 I;Dx4010 Diagnostic LED Functions

DS7200V2-EXP | Installation Guide | 2. System Installation
and Setup
EN | 35
Bosch Security Systems, Inc. | 04/12 | F01U253045-02
P2 –LED Enable
Use the diagnostic LEDs for troubleshooting
purposes. See Figure 50 to enable/disable these
LEDs.
Figure 50: DX4010 P2 Jumper Pin
Settings
1- P2 jumper pin location
2- Disabled position
3- Enabled position
Table 14: DX4010i/DX4010 Diagnostic
LED Functions
Diagnostic
LED
Function
BUS RX
LED
Data Bus receive data from control
panel.
BUS TX
LED
Data Bus transmit data to control
panel.
SER RX LED RS-232 receive data from serial
device.
SER TX LED RS-232 transmit data from serial
device.
2.8.5 DX4010i/DX4010 Addressing
Set the DIP switch address to 250 when using
the module to connect serial devices such as a
printer. The DX4010 does not use DIP Switches 7
and 8.
Figure 51: RS-232 Device DIP Switch
Setting
1- OFF position
2- ON position
Sample address setting shown is for Address
250
2.8.6 DX4010i/DX4010 Supervision
The control panel supervises communication to
the module when it is not used for a RPS direct
connection. If it fails to communicate with the
module, the control panel sends a “DBus
Missing” {125} report.
2.8.7 DX4010i/DX4010 DB9 Connector
The DB9 pins are configured as shown in Table
15 and Figure 52.
Table 15: DB9 Pin Configuration
DB9 Pin Number
Pin Configuration
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9
RI
Figure 52: DB9 Connector Layout
SER
RxTx
BUS
Rx Tx
LED
ENABLE
P6
P
2
2
3
1
ON
1 2 3 4 5 6
7 8
1
2
1 2 3 4 5
6 7 8 9