Bosch FPA-5000 - FPP-5000-TI Trouble Interface; FPP-5000-TI13 Communication Interface; Appendix; Options with Requirements under en 54-2:1997;A1:2006

Modular Fire Panel Appendix | en 157
Bosch Sicherheitssysteme GmbH System Information 09.2017 | 11.3 | F.01U.028.089
Installation of the power supply unit is described in RMH 0002 A Relay Module for Mains
Voltage, page 117.
7.6.2 FPP‑5000‑TITrouble Interface
Input voltage 15VDC to 30VDC
Maximum current consumption 1.15mA (at 24V), from LSN
Protection class (IEC60529) IP20
Addressing using eight DIP switches
Space required (H x W x D) approx. 127 x 96 x 60mm
The module is described in FPP‑5000 External Power Supply Unit Kit 24V/6A, page 121.
7.6.3 FPP‑5000‑TI13 Communication Interface
Input voltage 15VDC to 33VDC
Current consumption
– From panel rail at 24VDC
– From LSN
– 13.2mA
– 3.25mA
Protection class (IEC60529) IP20
Space required (H x W x D) approx. 127 x 96 x 60mm
The module is described in FPP‑5000 External Power Supply Unit Kit 24V/6A, page 121.
8 Appendix
8.1 Options with requirements under EN 54‑2:1997/A1:2006
The FPA-5000 provides the following options with requirements under EN 54‑2:1997/A1:2006:
– Output for activation of fire alarm devices
– Activation of fire alarm transmission equipment
– Output to fire alarm transmission equipment
– Alarm acknowledgement input from fire alarm transmission equipment
– Output for activation of fire protection equipment
– Output type A
– Output type B
– Output type C
– Fault monitoring of fire protection equipment
– Transmission delay
– Dependency of fire detection status on more than one alarm signal
– Type A dependency
– Type B dependency
– Alarm counter
– Fault signal status
– Fault signals from detection points
– Complete failure of power supply
– Output to fault signaling transmission equipment
– Disabled status
– Disabling of addressable points
– Test status