Bosch FPA-5000 - ANI 0016 a Annunciator Module; BCM-0000-B Battery Controller Module

Modular Fire Panel Installation | en 101
Bosch Sicherheitssysteme GmbH System Information 09.2017 | 11.3 | F.01U.028.089
4.9.2 ANI0016A Annunciator Module
Figure4.54: ANI0016A Annunciator Module
The annunciator module has 16 red and 16 yellow LEDs for displaying the operating states of
16definable detection points.
The activation of each LED is defined using the FSP-5000-RPS programming software.
This defines which detection points will activate the LEDs in which state.
The technical data can be found in ANI0016A Annunciator Module, page 150.
4.9.3 BCM‑0000‑B Battery Controller Module
The BCM-0000-B Battery Controller Module monitors the power supply of the entire panel and
regulates the temperature and time-controlled charging of up to four batteries.
The following functions are available using the keys on the module (1):
– The four LEDs on the module light up as a confirmation and LED test each time the key is
pressed.
– If the batteries have a voltage of between 18V and 21V, the battery charging procedure
can be started manually. Please note that a power supply must be available.
– The 24V switch outputs can be reset.
The switch output is deactivated if a fault occurs.