Bosch ICP-EZM2 - Set Point Type; Add a Device; Replace a Device

Set Point Type
The control panel selects the default device type based on the point type selection. The
following table lists the default device types that are assigned for a given point type:
Point Type Default Device Type Wireless Alarm Inputs (default)
Perimeter RADION mini door/
window
Magnetic
Interior RADION PIR motion Motion
Fire Instant RADION smoke Smoke
Perimeter Instant RADION glassbreak Glass Break
User Emergency RADION CO CO Detector
24-hour Trouble RADION repeater None
All other types RADION universal TX Wired Input
This configures the device type that is displayed in RPS and sets the default alarm mask bits
used to decide how the point status will be treated.
Add a device
When you select this menu option, the control panel initiates discovery mode for RADION
devices which enables the control panel to detect points that are not currently configured in
the RADION Receiver. The control panel periodically repeats the phrase “discovering devices”
until the RADION receiver replies with a point’s RFID.
1. While the “discovering devices” message is active, activate the wireless point that you
want to add to the system, or press the [#] to exit discovery mode.
2. After you activate a point, the receiver should see the point and notify the control panel.
The control panel announces the last 4 digits of the discovered point’s RFID and presents
the following choices:
3. To continue, press [1]. If you choose to continue, the control center announces “Please
wait”. During this time, the RFID is saved in the database and configured in the RADION
receiver.
4. To try again, press [2]. If you choose to try again, the control panel ignores the RFID that
was discovered and returns to the “discovering devices” message.
Replace a device
This option is presented when the RFID of a selected point has already been configured. If you
choose this option, the control panel follows the procedure identical to the “To Add a Device”
procedure.
The control panel initiates discovery mode and searches for RFID’s that are not currently
configured in the RADION receiver. The control center periodically repeats the phrase
“discovering devices” until the RADION receiver replies with a point’s RFID.
1. While the “discovering devices” message is active, activate the wireless point that you
want to add to the system, or press the [#] to exit discovery mode.
2. After you activate the point, the receiver should see it and notify the control panel. The
control panel announces the last 4 digits of the discovered point’s RFID and presents the
following choices:
3.6.1
3.6.2
3.6.3
Easy Series Control Panel System Installation and Configuration | en 35
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221