Bosch ICP-EZM2 - Programming; Basic Programming

Programming
Method Description
Basic Programming Basic Programming consists of a voice menu that contains the essential programming
items. Generally, finishing this programming section is usually all that is required for
a complete system.
Expert Programming Expert Programming allows access to all programming categories for full system
configuration. Only use expert programming if you have a special programming
requirement.
Table 5.1: System Programming Methods
Notice!
You can program control panels using the remote programming software RPS. Like Expert
Programming, RPS allows access to all programming categories. For more information on RPS
and how to use a programming key to streamline a multiple-panel install, refer to
Programming Access Options, page 38.
Notice!
For additional instructions and information for select programming items, refer to
Programming Details and Defaults, page 107.
For country code specific defaults for programming items, refer to Country Code Specific
Default Programming Codes, page 112.
Basic Programming
Enter Basic Programming
1. Select a system access option. Refer to System Access by Phone, page 38, System Access
by Phone, page 38.
2. Enter the installer passcode to enter the Installer Phone Menu. Refer to Configure the
System, page 32.
3. Press [3] to enter Basic Programming. Refer to the figure below for the Basic
Programming Menu options.
5
5.1
5.1.1
Easy Series Control Panel Programming | en 43
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221