Figure 4.2: Programming Key Lock Positions
1
Send data from control panel to key
2 Send data from key to control panel
1. Insert the key into the control panel board.
– Auto Transfer: If Expert Programming Item Number 123 = 1 (refer to Programming
Key Auto Transfer in System Programming Items, page 48), the programming key
automatically transfers data depending on the position of the lock switch.
– Manual Transfer: If Expert Programming Item Number 123 = 0, you must use the
Installer Menu to access the programming key.
The control center announces when data transfer is completed.
2. When the (√) LED flashes green, data transfer is successful.
If the (√) LED flashes red, the data transfer is unsuccessful. Remove and reinstall the key.
42
en | Programming Access Options Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
