Programming Access Options
You can access the system to make programming changes using:
– The Phone Menu
– Remote Programming Software (RPS)
– A Programming Key (using programming copied from a control panel previously
programmed using the Phone Menu or RPS)
System Access by Phone
Notice!
Once you configure a control panel using the Phone Menus, you can copy the programming
from the control panel to a programming key for use on another control panel, or for backup.
Refer to Programming Keys, page 41.
The Installer Phone Menu and User Phone Menu provide access to system functions such as
testing the system, programming the system, and adding or changing users.
The Installer Phone Menu requires the installer passcode.
The User Phone Menu requires either the master user (User 1) passcode for full menu access,
or a user passcode for limited menu access.
If the passcode length = four digits:
– The default installer passcode is 5432
– The default master user passcode is 1234
If the passcode length = six digits:
– The default installer passcode is 543211
– The default master user passcode is 123455
To access the system menus, select one of the options shown in the table Phone System
Access Options.
4
4.1
38 en | Programming Access Options Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
