Bosch ICP-EZM2 - System Test and Maintenance; Test the System

System Test and Maintenance
Test the System
Test the system for proper operation when installation and configuration are complete.
4 Press the System Test button on the control panel board for one sec. The system
provides instructions throughout the test. Follow all instructions.
4 Contact the central monitoring station (CMS) to verify that all necessary test reports
were received, including test reports from all installed input and output devices.
Maintain the System
Notice!
After system installation and any control panel programming, perform a complete system test.
A complete system test includes testing the control panel, all devices, and communication
destinations for proper operation.
Installer History Event Announcements
The Installer Menu speaks the event report status for each event. Refer to Configure the
System, page 32.
After the event entry and its parameters (if any) are spoken, the system will beep and then
speak the status using two numbers. The first number indicates the route 1 event status. The
second number indicates the route 2 event status.
The numbers in each announcement indicate the status as follows:
– 0 = The event was logged only
– 1 = The event was successfully transmitted for this route
– 2 = The transmission of this event failed for this route
– 3 = The event is still pending for this route
Refer to the following table for a history event announcement example.
Entry
Event Tone Route 1 Status Route 2 Status
Announcement “AC Fail” Beep “One” “Zero”
Event Messages
The following table shows:
– Non-standard event messages that appear in the history log, and
– Event messages for SMS Text and Voice formats
Event History Log Entry SMS Text Format Voice Format
Tamper
Enclosure
Tamper 0 Point Trouble 0 Tamper 0
Duress Duress; System Off User 22 Intrusion Alarm System
Off
Duress System Off User 22
Quick Arm System On Occupied User System
On Unoccupied User 0
System On Custom User 0
System On User 0 System On Occupied User 0
System On Unoccupied User 0
System On Custom User 0
7
7.1
7.2
7.3
7.4
66 en | System Test and Maintenance Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.