Bosch ICP-EZM2 - User Programming Items

Programming Item Item Number Selections Manuf. Default
Control Center
Backlight Extinguish
Mode
Control Center 1: 814 0 = Always on.
1 = Dim until user presence is
detected.
2 = Off until user presence is
detected.
3 = Off until user presents
token or enters passcode.
Control Center 1: 0
Control Center 2: 824 Control Center 2: 0
Control Center 3: 834 Control Center 3: 0
Control Center 4: 844 Control Center 4: 0
Default = Country-specific default. Select this programming item to hear the updated default value, or refer to
Country Code Specific Default Programming Codes, page 112.
User Programming Items
Programming Item Item
Number
Selections Manuf.
Defaul
t
Passcode Length 861 Set the length of all passcodes
(4 or 6 digits).
4
Installer Passcode (User 0) 7001 Four-digit Range: 1111 to 5555
Six-digit Range: 111111 to 555555
5432
54321
1
Master User Passcode (User 1) 7011 1234
12345
5
Duress User (User 22) Enabled 862 0 = Duress user disabled
1 = Duress user enabled
2 = Guard code enabled
Duress User passcode:
Six digits: 111111
Four digits: 1111
0
RFID Token Password 863 Use this item to prevent unauthorized copying of tokens
(00000000 to FFFFFFFF).
12345
678
Default = Country-specific default. Select this programming item to hear the updated default value, or refer to
Country Code Specific Default Programming Codes, page 112.
!
Caution!
Do not change the RFID Token Passwords item once tokens are added to the system.
5.2.9
Easy Series Control Panel Programming | en 61
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221