Figure 4.1: Modem Connections
1 Connection using internal modem
2 Connection using external modem
3 270 Ω to 330 Ω, ¼ W resistor (for Direct Connection option only)
3. If the first communication attempt fails, connect a 270 Ω to 330 Ω, ¼ W resistor in series
with the Tip House side.
Network
Select this method to establish a network connection between the RPS computer and the
control panel using the B450 or the B426.
Programming Keys
After you program a control panel using the Phone Menus or RPS, you can use a programming
key to transfer data from that control panel to another control panel. You can also use a
programming key to back up control panel data.
1. If the system is on, turn it off.
2. Place the key's lock switch in the desired position. Refer to the figure below.
4.3
Easy Series Control Panel Programming Access Options | en 41
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221
To Next Page
Loading...
