Bosch ICP-EZM2 - RADION glassbreak

LEDs
The repeater utilizes an external LED indicator to status the operation of the repeater. Refer to
the table below for LED descriptions.
LED Condition Pattern Description
On (Normal) – Indicates the repeater is functioning normally.
Off – Indicates there is a power failure to the repeater, or that the
receiver is not wired correctly.
Continuous Flash: 1 sec
rate for 5 sec
– Indicates the repeater is being powered up, and conduction
manufacturing test initializations.
Continuous Flash: A 3-
pulse signal, followed by
a short delay after the 3
rd
pulse
– Indicates the repeater has experienced a low battery
condition.
Continuous Flash: A 2
flash pattern continuous
pulse between On and
Off states with a short
delay after the 2
nd
pulse
– Indicates an AC power failure is detected.
– A communication failure within internal hardware
components inside the receiver
RADION glassbreak
The RFGB is a wireless transmitter used for detecting breaking glass. Throughout this
document, the term “glassbreak” refers to glass break.
Features include:
– Monitored battery status
– Four sensitivity settings
Dimension 101.42 mm x 112.90 mm x 35.00 mm
(3.99 in x 4.44 in x 1.38 in)
Power/Voltage Battery/CR123A, 3 VDC ( )
Power source type: C
Low battery level: 2.15V
Battery replacement Duracell DL123A, Lithium, Panasonic CR123A Lithium, or Sanyo
CR123A Lithium. Check your battery yearly to ensure proper
functionality.
Battery life Up to 5 years
Device testing To ensure proper functionality, the device must be tested at least
once every year.
Accoustic Capabilities Glass types and
thickness
Type Thickness
Plate 2.4 mm to 6.4 mm
(3/32 in to 1/4 in)
8.6.4
8.7
Easy Series Control Panel Device Specifications and Overview | en 77
Bosch Security Systems, Inc. System Reference Guide 2014.09 | 01 | F.01U.306.221