Bosch ICP-EZM2 - Page 4

4.3 Programming Keys 41
5
Programming 43
5.1 Basic Programming 43
5.1.1 Enter Basic Programming 43
5.1.2 Points 44
5.1.3 Report Configuration 45
5.1.4 Outputs 46
5.2 Expert Programming 47
5.2.1 ROM Firmware Version Items 47
5.2.2 System Programming Items 48
5.2.3 Communicator Programming Items 51
5.2.4 RPS Configuration Items 54
5.2.5 Route Reporting Options 54
5.2.6 Point Programming Items 57
5.2.7 Output Programming Items 59
5.2.8 Control Center Programming Items 60
5.2.9 User Programming Items 61
5.2.10 Factory Default 62
5.3 Exit Programming 62
6
Control Panel Event Codes (SIA and Contact ID) 63
7
System Test and Maintenance 66
7.1 Test the System 66
7.2 Maintain the System 66
7.3 Installer History Event Announcements 66
7.4 Event Messages 66
8
Device Specifications and Overview 68
8.1 Control Panel 68
8.1.1 Standby Battery Calculation 69
8.2 Control Center 70
8.3 DX2010 Input Expander 73
8.4 B426 Ethernet Communication Module 74
8.5 B450 Conettix Plug-in Communicator Interface 74
8.6 RADION repeater 75
8.6.1 Installation considerations 76
8.6.2 Wiring considerations 76
8.6.3 Specifications 76
8.6.4 LEDs 77
8.7 RADION glassbreak 77
8.7.1 Installation considerations 78
8.7.2 Testing 79
8.7.3 Low battery 80
8.7.4 Wall Tamper Tab 80
8.7.5 Maintenance 80
8.8 RADION TriTech 81
8.8.1 Mounting height and range adjustment 81
8.8.2 Sensitivity settings 82
8.8.3 Walk testing 82
8.9 RADION PIR 83
8.9.1 Walk testing 84
4 en | Table of Contents Easy Series Control Panel
2014.09 | 01 | F.01U.306.221 System Reference Guide Bosch Security Systems, Inc.