5-8
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual Access Programming
Ur=
3) Enter the user number you want to assign, then
press [OK].
d= 00
4) Using the numeric keys (1 to 8 / 0 = disabled) , enter
the timer group number.
5) Press [OK] to save and exit or press [MENU] to exit
without saving.
Access > User Properties > Ur-Acc
Access Group
-
MENU 1-4-5
1 Access Group 1 N
2 Access Group 2 N
3 Access Group 3 N
4 Access Group 4 N
5 Access Group 5 N
6 Access Group 6 N
7 Access Group 7 N
8 Access Group 8 N
This menu allows the master user or installer to assign
other users to one or more access groups. An access
group is used to allow and/or restrict which users have
access to various system outputs. Outputs can be used to
control doors, gates or roller doors etc.
You should discuss these options with your installer.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [1] + [4] + [5] + [OK].
The keypad will display the Ur = prompt.
Ur=
3) Enter the user number you want to assign, then
press [OK].
The keypad will display the current access groups
assigned to the user via the zone indicators.
-Bit-
1 2 4 5 6 8
4) Use keys [1] to [8] to toggle the corresponding access
groups on or o.
5) Press [OK] to save and exit, or press [MENU] to exit
without saving.
Access > Global Properties > L150
PIN Length
MENU 1-5-0
(*** System Wide Parameter ***)
0 4
00 = Variable 03 = 3 Digits 06 = 6 Digits
01 = 1 Digit 04 = 4 Digits 07 = 7 Digits
02 = 2 Digits 05 = 5 Digits 08 = 8 Digits
At factory default, all User PINs are set to be 4 digits long.
This menu allows you to change the length for all PIN
codes.
If you select the Variable code length option then you are
free to create pin codes with dierent code lengths. For
example User 1 could have a 4 digit code while user 3 can
have an 8 digit code.
Variable pin lengths are useful for increasing security
levels. Another use would be to program a single digit
code to trigger an output. To do this create a code which is
not assigned to an area and then map this to the required
output.
1) Enter your installer PIN + [MENU].
2) Enter [1] + [5] + [0] + [OK]. The keypad will display
the current PIN length.
d= 04
3) Select the required PIN length using the up and
down arrow keys then press [OK] to save and exit
or press [MENU] to exit without saving.
To Next Page
Loading...
