Brady M410 - Battery

M410 User Manual 6
Setup
Power
Battery
WARNING! Risk of explosion if battery is replaced by incorrect type. Dispose
of used batteries according to instructions.
WARNING!
• Do not expose batteries to temperatures above 140° F (50° C).
• Do not disassemble or mistreat the battery pack.
• Do not attempt to open, damage, or replace components in the battery pack.
• The battery pack should only be used and charged in an M410 printer.
• Do not use any other rechargeable battery pack other than M410-BATT in the
M410 printer.
• Do not allow metal or other conductive materials to touch the battery terminals
WARNING!
• Keep the battery pack away from sparks, flames, or other heat sources. Avoid
storage in direct sunlight.
• Keep the battery pack away from water.
• Never lay objects on top of the battery pack.
• Store your battery pack only in a cool, dry place.
• Keep the battery pack out of the reach of children.
• The battery pack must be recycled or disposed of properly according to
federal, state, and municipal regulations.
WARNING!
• The battery pack is not intended to be transportable. To prevent damage
when not in use, the battery pack should be stored in the original packaging
or in the M410 hard case or soft case which are available as accessories.
• Do not remove the battery pack from its original packaging until required for
use.
• Do not subject the battery pack to mechanical shock.
• Keep the battery pack clean and dry.
• Wipe the battery pack terminals with a clean dry cloth if they become dirty.
• After extended periods of storage, it may be necessary to charge and
discharge the cells or batteries several times to obtain maximum
performance.
• When possible, remove the battery from the equipment when not in use.