M410 User Manual 9
Setup
Printer Settings
To set the unit of measure:
1. Press
.
2
. Use the navigation keys to move through the menu until Units is highlighted
.
3
. Use the up and down navigation keys to select the desired un
it.
4
. Pr
ess
to accept the choice.
Pause/Cut
The Pause/Cut function allows you to remove a label from the printer before another label starts
printing.
To set pausing and cutting:
1. Press
.
2
. Use the navigation keys to move through the menu until Pause/Cut is highlighted
.
3
. Use the up and down navigation keys to select the desired function
.
•
On:
The printer pauses after each label.
•
Off:
The printer prints all labels in a file without pausing.
4. Press to accept the choice.
Printer Configuration
Use the Config menu to set the brightness, automatic shutdown, and to clean the printer.
To configure the printer:
1. Press
.
2
. Use the navigation keys to move through the menu until Config is highlighted
.
3
. Pr
ess
to accept the choice and display the printer configuration settings.
4. For information on how to use the screen, see “Settings Screens” on page 23
.
•
Shut Off Delay:
Set the amount of time, in minutes, that the printer should remain idle before
shutting down autom
atically
.
•
No Shut Off (AC):
Select this check box to turn off the automatic shutdown, which is not
needed when the printer is plugged in.
•
Backlight time:
Set the amount of inactive time after which the backlight on the screen should
shut off.
•
Always on:
Select this check box to keep the backlight on at all times while using the AC
adapter.
•
Brightness:
Change the brightness of the screen.
To Next Page
Loading...
