M410 User Manual 50
Editing Labels on the Printer
Serialization (Sequential Data)
3. Enter the values for the sequence.
• In the Start Value field, enter the start value of the sequence. If the start value is larger than
the end value, the series will decrement automatically.
• In the End Value field, enter the end value of the sequence.
• In the Increment field, enter the amount to increment each value in the sequence. For
example, a sequence beginning with 1 with an increment of 2 yields: 1, 3, 5, 7, 9, and so on.
4. For a simple sequence, select OK, press and you are done. If you wish to add a
second sequence, continue. The remaining steps result in one complex sequence on the
labels. To have the two sequences appear in different places on the label, see “To add multiple
sequences, displayed at different locations on the label:” on page 50.
5. Select the Add Seq 2 box.
6. Under Sequence #2, enter the Start Value, End Value, and Increment.
7. If you want the values to increment dependently, as described in “Advanced, Dependent
Example” on page 49, select Linked.
8. Select OK, and press . The sequence is placed on the labels.
Note: Linked serializations do not have to display at the same position on the label. They can be in
separate locations within the label. See below.
To add multiple sequences, displayed at different locations on the label:
1. Position the cursor on the label where you want the first sequence to display.
2. Press .
3. Enter the values for the first sequence.
• In the Start Value field, enter the start value of the sequence. If the start value is larger than
the end value, the series will decrement automatically.
• In the End Value field, enter the end value of the sequence.
• In the Increment field, enter the amount to increment each value in the sequence. For
example, a sequence beginning with 1 with an increment of 2 yields: 1, 3, 5, 7, 9, and so on.
4. Select OK and press to return to the editing screen.
5. On the editing screen, navigate to the next sequence location (cursor position) on the label.
6. Press . The values from the first sequence are already filled in.
7. Select the Add Seq 2 box.
8. In the Sequence #2 enter the start and end values for that sequence, as well as the increment.
9. Select OK and press .
To Next Page
Loading...
