For Windows XP installation of the driver do the following:
1. Temporarily disconnect the internet connection of the PC.
2. Connect the supplied USB cable between the probe and a USB port on the PC.
3. When asked to connect to Windows Update, select “No not this time”.
4. Select "Install from a list or specific location (Advanced)".
5. Select "Search for the best driver in these locations" and enter the file path.
6. If a warning appears, stating that the driver has not passed Windows Logo
testing, select “Continue anyway”.
7. Open the Device Manager (located in "Control Panel\System" then select the
"Hardware" tab and click "Device Manager"), open "Ports" - the probe appears
as a new COM port with the label "USB Serial Port". Note the port number of this
new COM port (e.g. COM3).
For operating systems other than Windows XP a similar driver installation procedure
may have to be performed. Refer to the documents part of the http://www.ftdichip.com
site for instructions.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
37
To Next Page
Loading...