Calibration
3-2 P/N M/97-520
Tools Required
The tools listed in Table 3-1 are required for calibrating the TT100 In-Line
Viscometer.
Table 3-1: Tools Required
Tool Quantity
Digital Volt Meter 1
#18 - 24 AWG Insulated Wires - 6 inches long 2
Medium Straight Blade Screwdriver 1
Small Straight Blade Screwdriver 1
5mm Hex Wrench 1
Calibration Bars 1 or 2*
* Dual range viscometers may be supplied with two calibration bars.
To Next Page
Loading...
