Brookfield TT100 - Figure 3-4:Torque Sensor Electronics Board Adjustment Component

TT100 In-Line Viscometer Installation, Operation, Maintenance and Service Instructions
P/N M/97-520 3-7
11. Remove the DVM connections and wires from J1 on the circuit
board.
12. Reconnect the milliampere output cable to J1 Pins 1 and 2 on the
torque sensor electronics circuit board.
13. Install the enclosure cover.
14. Turn power ON to the torque sensor electronics enclosure.
15. Refer to Section 4 - Operation.
Figure 3-4:Torque Sensor Electronics Board Adjustment Component Locations
1243
12
11
10
9
8
7
6
5
4
3
2
1
1234 123
PRIMARY - (RED)
PRIMARY + (GREEN)
SECONDARY + (YELLOW)
SECONDARY - (BLUE)
L1
L2
GROUND
SHIELD
+
J3
J2
J1
R17
R36
R18
R20
R19
R31
R56
R51
SIGNAL COMMON
LOW RANGE
HIGH RANGE
GROUND
-V
+V
-mA
+mA
GROUND - (PURPLE)