Brookfield TT100 - Figure 3-2: Typical Calibration after Viscometer Disassembly and Cleaning

Calibration
3-4 P/N M/97-520
Figure 3-2: Typical Calibration after Viscometer Disassembly and Cleaning
START
Perform Disassembly and
Cleaning Procedures
(Refer to Section 5)
Perform Single or Dual
Range Viscometer Span
Calibration
(Refer to Page 3-10 or 3-14)
END
Operate
Viscometer
(Refer to Section 4)
NOTE: This flowchart assumes that the Microsyn housing cover has not been removed
during the cleaning process.
Perform Preliminary
Torque Sensor Test
(Refer to Page 3-8)