V-7
11)Press the Continue button to implement FLASH CARD2 R/W TEST.
CARD2 R/W START
CARD2 R/W OK
CARD2 R/W OK: The flash memory card works correctly.
CARD2 R/W ERROR: The flash memory card has a problem.
NO FLASH CARD2: The flash memory card is not installed.
WP FLASH CARD2: The write protect switch on the flash memory
card is On.
12)Press the Continue button to implement the MIO CHECK.
MIO CHECK START
MIO OK
MIO OK: The MIO card works correctly.
MIO ERROR: The MIO card has a problem.
NO MIO BOARD: The MIO card is not installed.
13)Press the Continue button to exit the Line Test Mode. The printer is reset as
follows;
RAM SIZE = 16M
Now initializing
LJ WAIT 001P T1
LJ READY 001P T1
14)Turn off the power.
When this messages is
displayed, the printer may
be turned off.
However, if one of the
toner cartridges is not
installed or no paper is
loaded, a message such
as “14 NO CARTRIDGE”
or “CHECK TRAY” is
displayed.
To Next Page
Loading...
