Brother HL-2400C - Paper Exit Roller; Paper Exit Sensor (PT2)

VII-37
4.4.5 Paper Exit Roller
1) Remove the C ring, washer, and plastic bush from the left and right hand sides.
2) Remove the shaft support at both sides.
3) Remove the paper exit roller from the paper exit guide.
Fig.7-62
4.4.6 Paper Exit Sensor (PT2)
1) Disconnect the harnesses connected to the paper exit sensor.
2) Remove the paper exit sensor from the paper exit guide.
Fig.4-63
Paper Exit Sensor
Paper Exit Roller
Paper exit
g
uide
Paper exit guide