Brother HL-2400C - 3.4.3 Confirmation and Setting of Total Number of Printouts; 3.4.4 Setting of Number of Images for each Color

V-41
3.4.3Confirmation and Setting of Total Number of Printouts
The total number of printouts is stored in the RAM. Confirmation and setting of total
number of printouts can be carried out on the control panel.
<Purpose>
Total number of printouts will be reset when changing the MCTL PCB or executing an
NVRAM INITIAL.
<Procedures of Setting>
1) Execute 47 TOTAL PAGE in the Factory Mode.
2) Reset the total number of printouts.
3) After making the setting, execute 34 TOTAL PAGE to confirm that the desired
number of printouts in now set.
3.4.4Setting of Number of Images for Each Color
The number of printouts for each color (4 colors) is stored in the RAM. Confirmation and
setting of the number of images for each color can be carried out on the control panel.
<Purpose>
Number of images for each color will be reset when changing the MCTL PCB or
executing NVRAM INITIAL.
<Procedures of Setting>
1) Execute 48 EACH IMAGE in the Factory Mode.
2) Reset the number of printouts for each color.
3) After making the setting, execute 35 EACH IMAGE SET to confirm that the desired
number of images is now set.