Brother HL-2400C - Page 137

V-16
Code No. LCD Message Description of Message
14-1
CHECK FUSER OIL
14 CHECK [*5]
FUSER OIL[*F0]
•
The engine is idling.
•
The Ready LED is lit.
•
Replace the fuser oil bottle with a new
one.
•
This message will be automatically
cleared by opening & closing the
paper exit cover.
14-2
14 CHECK CLEANING
ROLLER[*4][*FC]
•
The engine is idling.
•
The Ready LED is lit.
•
Replace the cleaning roller with a new
one.
•
Execute the Clear Care Mode after
the replacement of the cleaning roller
to clear the Care Code [FC].
14-3
CHECK WASTE TONER PACK
14 CHECK
TONER PACK[*4]
•
The engine is idling.
•
The Ready LED is lit.
•
Replace the waste toner pack with a
new one.
•
This message will be automatically
cleared by opening & closing the front
cover while replacing the waste toner
pack. The message can also be
cleared by pressing the Font button.
15
MISPRINT
15 MISPRINT
[*6][*4]
•
The engine is idling.
•
The Ready LED is lit.
[*6] The type of misprint error is
indicated as follows;
NOPQR: No PRREQ-N signal is
available.
PAPER: No paper is available in
the feeder while executing the print
operation after receipt of the print
command.
•
This message can be cleared by
pressing the Font button.
16-1
16 ALIGN
FU.UNIT [*4]
•
The engine is stopped.
•
The Ready LED is lit.
•
The fusing unit is not installed.
Reconfirm the installation status of the
fusing unit.
•
This message will be automatically
cleared by opening & closing the
paper exit cover. The message can
also be cleared by pressing the Font
button.