V-18
Code No. LCD Message Description of Message
18-1
CLOSE PANEL
18 CLOSE PANEL
[*8] [*4]
• The engine is in standby.
• The Ready LED is lit.
[*8]: The open cover is indicated as
follows;
FRONT: Front Cover
TOP: Paper Exit Cover
• This message can be cleared by
opening & closing the indicated cover.
18-2
SET TR.UNIT
18 CLOSE TR.UNIT
[*4]
• The engine is stopped.
• The Ready LED is lit.
• The transfer unit is open. Reconfirm
the installation status of the transfer
unit.
• This message can be cleared by
opening and closing the rear access
cover.
19
SLEEP MODE
19 SLEEP MODE
[*4]
• The engine is idling.
• The Ready LED is lit.
• This mode is cleared by sending a
WAKE-UP command (EC24) from the
video controller.
• The printer is ready to print after the
warming-up process of the engine.
20
SERVICE CALL
20 SERVICE CALL
[*9]
• The engine is in standby.
• The Ready LED is lit.
[*9]: Service Call error code is indicated
as follows;
For the details of error codes, refer
to Chapter VIII “Troubleshooting” in
this manual.
To Next Page
Loading...
