Brother HL-2400C - Page 145

V-24
36 CLEAR CARE
Care Code counters displayed on the LCD can be cleared. Make sure that you clear the
relevant CLEAR CARE mode whenever replacing periodical replacement parts with new
ones. This mode should only be used to reset the counters after replacement of faulty
consumables before their life expectancy is reached. For normal life replacement use the
resets available in the Video controller mode
Procedure
Description of Procedures LCD Message
1) Press the Continue button after selecting
Screen (a) “CLEAR CARE” mode.
(a) → (b)
2) Using the Set or ▼ button, move the cursor
to select the applicable CARE code and then
press the Continue button.
(b) → (c)
3) To clear the counter in CLEAR CARE, use
the Set or ▼ button to select YES and then
press the Continue button.
Fuser cleaner (c) (g)
OPC belt cartridge (d)
Fusing Unit (e)
120K replacement kit (f)
6) Press the Font button to exit the CLEAR
CARE mode. (g) → (h)
SERVICE MODE
CLEAR CARE
36 CLEAR CARE
CARED FC ROLL
YES/NO
a)
b)
c)
d)
e)
f)
CARED BC UNIT
YES/NO
CARED FU UNIT
YES/NO
CARED 120K UNIT
YES/NO
36 CLEAR CARE
g)
SERVICE MODE
TEST PRINT
h)
No.=<1,2,3,4,5,6,7,8,9>
No.=<1,2,3,4,5,6,7,8,9>