Brother HL-2400C - Page 188

VI-23
2) Push the tab of the left hand side to
remove the shaft from the installation
hole at the right side first, then
remove the transfer roller. (Fig.6-20)
3) Install a new transfer roller into the
printer.
4) Fix the transfer roller with the lock
lever.
Fig.6-20
Sequence of Assembling
1) Close the rear access cover.
2) Plug the power cable into the power outlet and turn on the printer.
3) Upon completion of the warming-up process;
Press the Reset button while holding down the Shift button, and select
“RESET PARTS LIFE” and then “TRANSFER ROLLER”.
Tab