Brother HL-2400C - Page 190

VI-25
Sequence of Replacement
1) Pull the right hand side of the paper
discharger slightly, then lift it out of
the transfer unit to remove the paper
discharger. (Fig.6-22)
Fig.6-22
2) Clean the area where the paper
discharger unit is mounted. (Fig.6-
23)
3) Install the new paper discharger unit
into the transfer unit.
Fig.6-23
Sequence of Assembling
1) Close the rear access cover.
2) Plug the power cable into the printer, and turn on the printer.
3) Upon completion of the warming-up process;
Press the Reset button while holding down the Shift button, and select
“RESET PARTS LIFE” and then “120K KIT”.
Lever
Paper Discharger