Brother HL-2400C - Page 318

A-15
6.6 Packing
1) Re-install the fusing unit into the
printer.
i) After setting the fusing unit in place,
lightly press down the unit to firmly
connect to the connector on the
base.
ii) Tighten the securing screws while
pressing down the fusing unit.
Check the metal hook of the screw
at the left hand secures the fusing
unit correctly.
iii) Close the rear access cover and
top cover.
2) Check the following items are packed
in the starter kit packing;
Four toner cartridges (K, Y, M, C),
OPC belt cartridge, Oil bottle, Fuser
cleaner. (Refer to the figure as shown
on the right.)
3) Put the printer into the polyethylene
bag.
4) Pack the printer, the starter kit packing,
the waste toner pack, and power cable
in the carton using the original packing
material.
5) Seal the outer carton firmly.
Fusing Unit
OPC Belt
Cartridge
Toner Cartridge
Fuser
Cleaner
Starter Kit Packing
Oil Bottle
Printer
Power
Cable
Waste Toner
Pack
Starter Kit Packing
Outer Carton