Brother MFC-9560CDW - Page 59

2-20
Confidential
6A Fuser unit error. (The center
thermistor does not detect 60 °C
within the specified time.)
2-57
6B Fuser unit error. (The center
thermistor does not detect 100
°C within the specified time.)
2-57
6C
Fuser unit error. (The center
thermistor detects 270 °C or
higher temperature for 1 second.)
2-57
6D Fuser unit error. (The center
thermistor detects 60 °C or
lower temperature for 1 second
during standby or printing.)
2-57
6E Fuser unit error. (The center
thermistor fails to detect the
temperature rise even after the
halogen heater is turned ON
during printing and 15 second
pass.)
2-57
6F Fuser unit error. (The center and
side thermistors detect extremely
high temperature.) (Detection of
hardware.)
2-58
70 Fuser develop motor error. 2-58
71 Laser unit polygon motor error. 2-59
72 Beam detecting sensor (Black/
Yellow) error of the laser unit.
2-59
73 Beam detecting sensor (Cyan/
Magenta) error of the laser unit.
2-59
74 The color toner reached the end
of life during printing.
2-59
75 Cooling down the inside of the
machine to protect it.
2-60
76 Fuser unit error. (The center
thermistor detects the sharp
temperature rise.)
2-60
78 Fuser unit error. (The center
thermistor detects the sharp
temperature fall.)
2-60
Error
codes
Problem
Refer
to:
7A Engine PCB error. (detection of
PF drive motor lock error.)
2-60
7B Engine PCB error. 2-61
7C Communication error between
the engine PCB and main PCB.
2-61
7D Dirt on drum unit. 2-61
7E Belt unit is at the end of life.
(The operation is stopped.)
2-64
7F
FAX paper size is incorrect.
(Menu setting)
2-64
80
FAX paper size is incorrect. (The
actually loaded paper is small.)
2-64
81 Incorrect density sensor
measurement value when
implementing adjustment of
color density.
2-65
82 Density patch measurement is
not completed normally when
implementing adjustment of
color density.
2-65
83 Drum unit error.
(An drum error occurred after
the drum unit reached the end of
life.)
2-66
84 Paper jam at the rear section of
the machine.
2-66
85 The paper tray 1 is not installed. 2-67
86 The paper tray 2 is not installed. 2-67
87 Toner of the color which is being
used reaches the end of life
when implementing adjustment
of color density.
2-68
88 Paper jam inside the machine. 2-68
89 Unsupported paper size is used
for duplex printing.
2-69
8A Paper jam in the paper tray 1. 2-69
8B Paper jam in the paper tray 2. 2-70
8C Paper jam in the MP tray. 2-71
Error
codes
Problem
Refer
to: