2-13
Confidential
First Line Status
Error
Code
Reference
Hub is Unusable
A USB device equipped with a USB hub or a hub
is set.
2-82
Image too Long
The image cannot be corrected because it is too
large.
Image too Short
The image cannot be trimmed because it is too
small.
Ink Absorber Full
The purge count or flushing count reached the
upper threshold.
46
2-34
Ink Absorber Near
Full
The purge count or flushing count will soon reach
the upper threshold.
Ink Low
The ink remaining sensor detected that the ink
replacement period is approaching.
Install Starter Ink
A cartridge without the necessary ink volume for
initialization was loaded during initialization.
24
2-22
Low Temperature
The head thermistor detected that the room
temperature is too low.
Media Error A problem was detected in the memory card.
Media is Full
The memory of the media slot is full, or there are
999 or more files in the memory.
No Caller ID There is no Caller ID information.
No File
There are no printable files in the memory card or
the USB flash memory.
No Ink Cartridge No ink cartridge loaded.
2A, 2B,
2C, 2D
2-24
No Paper Fed
The registration sensor detected that there is no
recording paper in paper tray 1.
2-52
No Response/Busy The receiver is busy or there was no response. 2-82
Out of Fax Memory
The amount of accumulated data in the memory
through Memory Receive exceeded the limit.
2-84
Out of Memory There is not enough memory. 2-84
Paper Jam
The registration sensor, paper width sensor, and
CR encoder sensor detected a paper jam.
0E, 18, 31,
38, 3C, 82,
84, 8A, 8C
2-19,
2-20,
2-27,
2-29,
2-30,
2-41,
2-42,
2-43
Touchscreen Init.
Failed
After the power was turned on, the screen was
touched before touch panel initialization could be
completed.
ED
2-51
Unable to Print Some problem occurred during printing.
Unable to Scan Some problem occurred during scanning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
