EasyManuals Logo

Brother MFC MFC-9120CN User Manual

Brother MFC MFC-9120CN
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
146
Print Unable XX
(XX=Error Code)
The machine has a mechanical
problem.
Do one of the following:
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
60 hours without losing faxes stored in
the memory. See Transferring your faxes
or Fax Journal report on page 148.)
If the problem continues, call your
Brother dealer.
Print Unable 1A One of the issues that can cause
this error is that condensation
may form inside the machine after
a room temperature change.
Turn the power switch off and fully open the
top cover. Leave the machine off and open
for 30 minutes to remove any condensation
from inside the machine, then close the top
cover and turn the machine on again. If this
does not clear the error, call your dealer or a
Brother Customer Service.
Protected Device
(MFC-9320CW only)
The protect switch of the USB
Flash memory drive is on.
Turn off the protect switch of the USB Flash
memory drive.
Registration Registration failed. Press Mono Start or Colour Start and try
again.
Do one of the following:
Turn off the machine’s power switch.
Wait a few seconds, then turn it on again.
Try Manual Registration, Menu, 4, 7.
(See Manual Registration on page 165.)
Put in a new belt unit. (See Replacing the
belt unit on page 177.)
If the problem continues, call your
Brother dealer.
Rename the File
(MFC-9320CW only)
There is already a file on the USB
Flash memory drive with the
same name as the file you are
trying to save.
Change the file name of the file on the USB
Flash memory drive or the file you are trying
to save.
Replace Belt It is time to replace the belt unit. Replace the belt unit. (See Replacing the
belt unit on page 177.)
Replace Drums It is time to replace the drum
units.
Replace the drum units.
(See Replacing the drum units on page 174.)
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter.
(See Resetting the drum counter
on page 177.)
Replace Drum(X)
1
It is time to replace the drum unit
for the indicated colour.
Replace the drum unit for the colour
indicated on the LCD.
(See Replacing the drum units on page 174.)
Error Message Cause Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother MFC MFC-9120CN and is the answer not in the manual?

Brother MFC MFC-9120CN Specifications

General IconGeneral
Print TechnologyLaser
ConnectivityUSB 2.0, Ethernet
Duplex PrintingManual
ADF Capacity35 sheets
Fax Modem Speed33.6 Kbps
FunctionsPrint, Copy, Scan, Fax
Maximum Printing Speed (Black)17 ppm
Maximum Printing Speed (Color)17 ppm
Monthly Duty CycleUp to 30, 000 pages
Scanning ResolutionUp to 19200 x 19200 dpi (interpolated)
Optical Scan Resolution1200 x 2400 dpi
Memory64 MB
Paper Handling250-sheet input tray
Scanner TypeFlatbed
Copy SpeedUp to 17 cpm
Paper Capacity250 sheets
Print SpeedUp to 17 ppm (Black/Color)

Related product manuals