Calix E3-48C - Creating Voice Service Profiles

155
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
6. Click Create. When the Operation Status in the Task Progress window shows Success,
click OK.
7. To add a service to an xDSL Bonding Group, see Configuring Data Services (on page 177)
and Configuring Video Services (on page 189).
For CLI:
 create dsl-bond-interface <intfc-name> [description|subscriber-
id|dscp-p-bit-map|ip-prec-p-bit-map|eth-sec-profile|immediate-
leave|ds-min-rate|us-min-rate|admin-state]
 set dsl-port <id> <intfc-name>
 set dsl-bond-interface <intfc-name> [eth-svc|description|subscriber-
id|dscp-p-bit-map|ip-prec-p-bit-map|eth-sec-profile|immediate-
leave|ds-min-rate|us-min-rate|admin-state]
 show dsl-bond-interface [detail|vlans]
 show dsl-bond-interface <intfc-name> [detail|eth-svc|members|vlans]
 show dsl-port [port]
[advanced|all|basic|inventory|psd|status|subcarriers]
 clear dsl-bond-interface igmp-counters
 clear dsl-bond-interface <intfc-name> [igmp-counters|pppoe]
Creating Voice Service Profiles
This section describes how to create profiles and objects that will be associated with voice
services provisioned on a VDSL2 card Voice (POTS) port.
Creation of following profiles and objects are described:
 IP Host for Voice Services
 Dial Plan
 SIP Gateway Profile
 TDM Gateway Profile
 TDM Gateway Service Group
 H.248 Gateway Profile
 H.248 Gateway
Next steps:
After completing the creation of profiles for voice services, see the following section to
continue configuring voice services:
Configuring Voice Services (on page 200)