Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
Chapter 2
Configuring VDSL2 Applications
This chapter describes how to setup VDSL2 applications, including configuring the E-Series
system, creating profiles, and then adding subscriber services.
Note: For procedures on initial turnup and network configuration specific procedures, see
the Calix E7 User Guide or the Calix E3-48/E5-48/E5-48C User Guide. See the E7 Maintenance
and Troubleshooting Guide for a procedure on VDSL2 Single Ended Line Test (SELT) that is is
a DSL pre-provisioning test tool used to assess the line capability prior to installing a modem
at the customer premise.
Topics Covered
This chapter covers the following topics:
1. Configure network uplinks for VDSL2 services
2. Creating system profiles that support VDSL2 applications
3. Configure subscriber services
To Next Page
Loading...