184
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
Parameters
You can provision the following parameters for a data service on an xDSL port:
Parameter Description Valid Options
Subscriber ID Subscriber ID information, such as phone number, or account
Description Optional description field for the port, subscriber address, name, or
Service Tag Action* Name of service tag action to apply to the service.
If the "specified in service" option was selected for either the Outer
Tag or the Inner Tag in the service tag action, enter the applicable
To create a data service on an xDSL port
1. On the Navigation Tree, click the xDSL port or bonding group on which you want to
add a data service.
2. In the Work Area, click Port > Services > Form.
Note: To create a service on an xDSL Bonded interface, on the Navigation Tree, click
the xDSL Group under the VDSL2 card, and then in the Work Area, click Services >
Form.
3. Reference the table above to configure the parameters.
4. In the menu, click Apply.
5. Verify your modem train rate using the Port > Status tab.
For CLI:
add eth-svc <service name> to-interface <dsl-port> bw-profile <bw-
profile-name> svc-tag-action [outer-vlan <vlan ID> inner-vlan <vlan
ID> mcast-profile <profile name> description <service> admin-state
[enabled|disabled]]
add eth-svc <service name> to-dsl-bond-interface <b-intfc> bw-
profile <bw-profile-name> svc-tag-action [outer-vlan <vlan ID>
inner-vlan <vlan ID> mcast-profile <profile name> description
<service> admin-state [enabled|disabled]]