Canon EOS C80 - Recording Remotely Using an XC Protocol Compatible Controller;Application; Recording Remotely Using the RC-IP100;RC-IP1000 Remote Camera Controller

Recording Remotely Using an XC Protocol Compatible Controller/Application
190
Recording Remotely Using an XC Protocol Compatible Controller/
Application
Set the IP address of the camera on the optional XC Protocol compatible RC-IP100/RC-IP1000 Remote Camera
Controller or Remote Camera Control Application
1
to control the camera remotely. You can also control the
camera remotely using Multi-Camera Control
2
on a smartphone connected to the same network as the camera.
1
Available from your local Canon website.
2
Available from the App Store.
1 In CAMERA mode, activate the network functions (A 166)
• Select a connection setting with the [XC Protocol] function setting.
Recording remotely using the RC-IP100/RC-IP1000 Remote Camera Controller
You can remotely control camera settings like the aperture and shutter speed, or change picture related settings
like the knee and sharpness. For more details on the connection, settings and the RC-IP100/RC-IP1000 refer to
the RC-IP100/RC-IP1000 instruction manual.
NOTES
• When connected to the camera, the following functions of the RC-IP100 cannot be used.
- F1/F2/F4 knob: PT Speed, R Gain, B Gain, Noise Reduction, PT Speed/None.
- USER1/USER2 button: Shooting Mode, Preset Color Settings, Noise Reduction, Knee-Automatic, Preset
Freeze, Create Thumbnail.
- Control lever: pan/tilt operations.
- TRACE tab.
- FUNC tab: Soft Zoom Control, PT Acceleration, Image Stabilizer, Focus Limit, Auto Slow Shutter, Gain
Boost, Flicker Reduction, ND Filter Mode, IR Cut, Save, Auto Tracking, Status, Tracking Sensitivity, Display
Size, Auto Zoom, Auto Select, Auto Loop No., Auto Loop, Operation/Direction, Wiper, Washer, AUX1,
AUX2, AUX3, AUX4, Enhanced ND Filter.
• The following RC-IP1000 buttons/lever/dials cannot be used when connected to the camera.
- Camera settings area: ABB button, FULL AUTO button.
- Pan/tilt operation area: PAN/TILT lever, pan/tilt SPEED dial.
You cannot use functions that are not supported by the camera. If you assign an unsupported function to the
menu operation area, USER buttons area, F1/F2/F3/F4/F5 dials, or USER 1 to USER 10 buttons in the
SYSTEM menu, it will be displayed in gray on the RC-IP1000's LCD panel.
• The zoom can only be operated when a compatible lens (A 242) is attached to the camera.
• [PRESET] focus and zoom settings can only be used when a compatible RF lens / EF Cinema lens is attached
to the camera (CN-E70-200mm T4.4 L IS KAS S, CN-E18-80mm T4.4 L IS KAS S or RF24-105mm F2.8 L IS
USM Z).
• Even if the camera’s controls are locked (key lock), you can use the RC-IP100/RC-IP1000 to operate the
camera (A 15).
NOTES
• About changing custom picture related settings
- If a protected custom picture file is selected on the camera, custom picture related settings cannot be
changed using the remote camera controller or Remote Camera Control Application.
- Adjusting custom picture related settings using the remote camera controller or Remote Camera Control
Application will change the settings registered under the currently selected custom picture file. If you want to
keep an important custom picture file, backup it or select in advance a custom picture file you do not mind
changing.