Canon EOS C80 - Video Format

49
Recording Video and Photos
Top o f th e screen
Icon/Display Description Custom Display
Recording media status, estimated remaining recording time and recording format 2: [Remaining Rec Time]
, (in green)
000 min
/ : SD card
The card’s status is indicated by the icon’s color: in green – can record; in yellow –
card almost full (5 minutes or less); in red – card almost full (less than 1 minute); in
white – reading the card.
• The card selected for recording is indicated with a mark.
, (in red) END Card is full.
, (in red) No card or cannot record on the card.
r, , ,
,
Video format ( A 60) and audio format ( A 112).
Recording operation 2: [Recording Mode]
STBY, ÜREC Normal recording: record standby, recording.
S&F STBY,
S&F
ÜREC
Slow & fast motion recording (A 112): record standby, recording.
PRE STBY,
PRE
ÜREC
Pre-recording (A 115): record standby, recording.
CONT, ÜCONT Continuous recording (A 116)
FRM STBY,
FRM
ÜREC,
FRM
ÜSTBY
Frame recording (A 117): record standby, recording.
INT STBY,
INT
ÜREC,
INT
ÜWAIT
Interval recording (A 117): record standby, recording.
0s / 00m00s Interval counter (A 117). 2: [Interval Counter]
REC`, STBY`
EXT REC`, EXT STBY`
Recording command (A 152).
"EXT" is displayed when there is no recording media.
2: [Rec Command(EXT
REC)]
4
Double slot recording (A 38). 2: [Recording Mode]
00.00P, 00.00i Frame rate (A 60).
When slow & fast motion recording is activated, the shooting frame rate is also
displayed (000/00.00P).
2: [Frame Rate]
Tilt 000.0°
Roll 000.0°
Level (numeric) (A 32) 1: [Level (Numeric)]
C
Key lock (A 15). 1: [Key Lock]
00:00:00.00 / 00:00:00:00
R, P, F, E
Time code (A 93).
Time code status (A 94).
2: [Time Code]
Power supply level indicator 2: [Remaining Battery]
è  é 
ê  ë 
(in red)
000 min
Remaining battery charge of a BP-A30N or BP-A60N Battery Pack and estimated
remaining usage time (in minutes).
• When is displayed, replace the battery pack with a fully charged one.
• Depending on the conditions of use, the actual battery charge level may not be
indicated accurately or may not match the levels shown on the [B System
Setup] status screen or the indicators on the battery pack.
DC IN 00.0V Power supply voltage when using an AC adapter.
• When the voltage falls below the selected low-power warning level (A 207),
the voltage will be displayed in red.