Recording Video and Photos
52
Peripheral Border Display
You can apply the peripheral border display to all display levels. With the peripheral border display, the camera’s
image is reduced slightly so the onscreen displays are shown mostly around it and not on top of it, partially
hiding it. The peripheral border is linked with the display level. You can select the levels that use the peripheral
border with the > [¢ Monitoring Setup] > [Apply Peripheral Border] setting.
• The peripheral border is not applied to video output to the SDI OUT terminal.
Displaying the Tally OSD
While recording (REC), the tally OSD (red frame or bar) can be displayed on the screen. Displaying the tally OSD
allows you to easily check whether recording is in progress even when viewing the screen from a distance.
1 Select > [¢ Monitoring Setup] > one of the [Tally OSD:] settings > [On].
• Confirm and/or change the screen for tally OSD display and the output destination.
2 Select > [¢ Monitoring Setup] > [Tally OSD Settings] > Desired option.
Tally OSD Settings List
3 Select > [¢ Monitoring Setup] > [Tally OSD Position] > Desired option.
• Recorded video/still images are not affected.
[Tally OSD Settings] Tally Input State Recording Status (REC) Tally OSD Lamp Color
[Tally In (PGM/PVW)]
PGM
—
Red
PVW Green
PGM + PVW Amber
[REC] —
Recording Red
[REC/Tally In (PGM/PVW)]
—
PGM
Record Standby Mode
Red
PVW Green
PGM + PVW Amber
Full-screen display Peripheral border display
To Next Page
Loading...
