1
Press the Load button.
2
Press â–² or â–¼ to select Roll Paper, and then press the OK button.
Note
•
If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press â–² or â–¼ to select Yes, and then press the OK button. Remove the paper and go to the next step.
3
Open the Roll Feed Unit Cover.
4
Holding the Roll Holder flange (a), load the Roll Holder
shaft into the guide grooves (b) on both sides of the
Roll Holder Slot. At this time, load the shaft so that the
color of the Roll Holder shaft (c) matches the color of
the guide groove.
Caution
•
Do not release the flanges until you load the holder fully in the Roll Holder Slot. Rolls are heavy, and dropping
a roll may cause injury.
•
Be careful not to pinch your fingers between the guide grooves (b) and the Roll Holder shaft (c) when loading
rolls.
Important
•
Do not force the Roll Holder into the printer with the right and left ends reversed. Otherwise, it may damage
the printer or Roll Holder.
Note
•
If it is difficult to load rolls from the front of the printer, load rolls from the back of the printer.
Loading Rolls in the Printer
iPF6400SE
User's Guide
Handling and Use of Paper Handling rolls
366
To Next Page
Loading...
Need help?
General