Setting Item Description, Instructions
Adjust
Printer
Head
Posi.
Adj.
Other
Manual Input the setting values from the adjustment pattern printing
results and adjust the printing position to fix misaligned
printing. Normally, select Standard. However, when printing
on special paper, or if printing is not improved after Stand-
ard, try Manual. (See "Manual Adjustment to Straighten
Lines and Colors.") ➔P.554
Feed
Priority
Adj. Pri-
ority
Automatic Specify exact paper feeding, if desired. Normally, select Au-
tomatic. Choose Print Quality for attractive printing.
Choosing Print Quality also makes banding less noticea-
ble. Choose Print Length if you prefer to feed the paper an
exact amount.
Print Quality
Print Length
Adj.
Quality
Auto(GenuinePpr) Specify this mode with paper identified in the Paper Refer-
ence Guide. (See "Displaying the Paper Reference
Guide.") ➔P.356
The printer prints and reads a test pattern for automatic ad-
justment of the feed amount. (See "Automatic Banding Ad-
justment.") ➔P.559
Auto(OtherPaper) Specify this mode with paper not in the Paper Reference
Guide. (See "Displaying the Paper Reference
Guide.") ➔P.356
The printer prints and reads a test pattern for automatic ad-
justment of the feed amount. Note that this function takes
more time and consumes more ink than Auto(Genu-
inePpr). (See "Automatic Banding Adjustment.") ➔P.559
Manual Use this mode with highly transparent media or other paper
for which Auto(GenuinePpr) or Auto(OtherPaper) cannot
be used.
Print a test pattern for adjustment of the feed amount based
on the type of paper. (See "Manual Banding Adjust-
ment.") ➔P.560
Adjust
Length
Adjust-
ment-
Print
A:High Print a test pattern for particular types of paper to compen-
sate for paper stretching or shrinkage, after which you enter
the amount of adjustment. (See "Adjusting Line
Length.") ➔P.563
B:Standard/Draft
Change
Settings
A:High Displayed when you have selected Feed Priority > Adj.
Priority > Print Length.
Adjustment relative to the amount of stretching or shrinkage
of the current paper.
Enter either the adjustment results from AdjustmentPrint
or the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends to
shrink, decrease the feed amount by choosing a lower ad-
justment value. (See "Adjusting Line Length.") ➔P.563
B:Standard/Draft
Adj Far Ed Feed Choose Yes to adjust the feed amount for the trailing edge.
Mainte-
nance
Head Cleaning Clean the Printhead. (See "Cleaning the Print-
head.") ➔P.577
Choose Head Cleaning A if printing is faint, oddly colored,
or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or if
printing is not improved by Head Cleaning A.
Nozzle Check Print a test pattern to check the nozzles.
Menu Settings
iPF6400SE
User's Guide
Control Panel Printer Menu
478
To Next Page
Loading...
Need help?
General