Important
• If you are not using the optional Media Take-up Unit when printing long documents such as banners, spread a clean
cloth or paper on the floor. Use the Output Stacker to prevent long printed documents from being soiled by the floor
after they are printed. (See "Using the Output Stacker.")
→
P.571
Note
• For details on supported sizes and types of rolls, see Paper Sizes or the Paper Reference Guide. (See "Paper Sizes.")
→
P.528 (See "Types of Paper.")
→
P.528
• To wait until the ink dries after printing before cutting the roll, set Drying Time in the printer driver. (See "Specifying the
Ink Drying Time for Rolls.")
→
P.550
• Once you have used all the paper on a roll, clean the platen. If the Platen inside the Top Cover becomes dirty, it may
soil the underside of paper. (See "Cleaning Inside the Top Cover.")
→
P.943
1
Turn the printer on. (See "Turning the Printer On and
Off.")
→
P.23
2
Load the roll on the Roll Holder. (See "Attaching the Roll
Holder to Rolls.")
→
P.536
iPF8400
Loading and Printing on Rolls
User's Guide
Basic Printing Workflow Printing procedure
25
To Next Page
Loading...
Need help?
General
