Turning the Printer On and Off
Packing Printer
1.
Disconnect power cord and interface cable.
1.
Important
• Turn off the printer before you unplug it. Unplugging the printer before it is off and moving it may
damage the printer. If you accidentally unplug the printer, plug it in again, reinstall the ink tanks,
and follow this procedure again.
2.
Tape down printer covers to secure them, in the reverse order of tape removal during
2.
installation.
3. Remove the stand by reversing the installation procedure, when it was attached to the3.
printer.
4. Disassemble and repackage the stand by following the installation procedure in reverse.4.
5.
Repack roll holder, holder stopper, and printer in shipping materials, and then package
5.
them in shipping box.
619
To Next Page
Loading...
