Feed the Stitch-wire
Step Action Information
1 Touch START .
2 Set the number of stitches to 6.
Touch BASIC > STITCHES.
3 Hand-feed or print an A4 or larger
size test job.
Enter the correct settings on the touch
screen according to the size and thickness of
the job.
The stitch-wire loads automatically during
the stitch head cycle.
4 Check that the stitch-wire is loa-
ded.
Check that a stitch is made. If needed, repeat
the previous step.
If a stitch is still not made, repeat the proce-
dure. Install the Stitch-wire into the Stitch
Head.
Install the Stitch Wire into the Stitch Head
on
page 126.
5 Reset the number of stitches on
the touch screen.
Feed the Stitch-wire
128
Chapter 7 - Maintenance
To Next Page
Loading...