Canon Oce BLM550+ - Operate the Booklet Maker Offline

Operate the Booklet maker offline
Introduction
You can hand feed sets into the Booklet maker if offline operation is needed. The machine
operates when you push the two buttons.
When to do
• To check the settings are correct
• To make a small number of books offline
IMPORTANT
Do not put your hands in the gathering area while the machine is in operation. Use two hands to
push the buttons. For safety reasons, this task is for a single operator. Do not allow another
person to help you.
NOTE
Do not use this function when SET THICKNESS is set to AUTO. The SET THICKNESS must be the
correct setting for the book.
Procedure
1.
Enter the correct settings on the touch screen, according to the size and thickness of the job.
2.
Touch START
3.
Open the connecting bridge cover.
4.
Open the gathering area cover.
5.
Put the set in the gathering area with the middle pages of the book face up.
6.
Press the two buttons and hold for 9 seconds or until you hear the folder operate. The time
interval changes according to the number of stitches.
Operate the Booklet maker offline
Chapter 5 - Standard Tasks
55