Run the job
Procedure
1.
Make sure the adjustments on the Booklet maker are complete before you release the print job
from the print queue.
2.
Start the print job. The Booklet maker starts automatically.
3.
Check the quality of the first book.
4.
If the quality is not acceptable, make adjustments (see
Book Quality
on page 64).
Result
During the job
• Unload books from the Stacker before the Stacker is full. The Booklet maker displays no
message when the Stacker is full.
• Unload books from the optional Book Stacker (see
Unload the Book Stacker
on page 57). The
Booklet maker displays a message when the Stacker is full. The Booklet maker stops.
• Empty the trim bin from time to time. The Booklet maker displays a message when the trim bin
is full
Empty the Trim Bin
on page 51.
Run the job
Chapter 3 - How to run the Booklet maker
25
To Next Page
Loading...