Introduction
This chapter describes the standard tasks that are needed in the day-to-day operation of your
Booklet maker.
Load and Save the Job Settings
Introduction
The current job settings can be saved to memory and reloaded for use again at a later date. Load
the 'Default Job Template' to reset the Booklet maker to normal settings.
Save a job
1.
Touch LOAD & SAVE
> SAVE.
2. If these options appear, select one.
•
REPLACE to over-write the previous job with the current job settings.
•
SAVE NEW to save the current job with a new name.
•
CANCEL to cancel the job save.
3. Enter the name for the job on the keyboard.
4.
Touch OK or CLOSE.
Load a job
1.
Touch LOAD & SAVE .
2. Touch the job name or use the Up arrow or the Down arrow to select the job.
3.
Touch LOAD.
4. Wait until the Booklet maker has made the adjustments.
Reset the Booklet maker to default settings
1.
Touch LOAD & SAVE
.
2.
Select the Default Job Template from the list of jobs.
3.
Touch LOAD.
4.
Touch YES.
Load and Save the Job Settings
42
Chapter 5 - Standard Tasks
To Next Page
Loading...