Step Action Information
5 Enter the sheet thick-
ness.
Or
Touch SET THICKNESS. Set AUTO to ON. Use '+' or '-' to en-
ter the SHEET THICKNESS.
Enter the set thick-
ness. See
Quality in-
structions
on page 18.
Touch SET THICKNESS. Set AUTO to OFF. Use '+' or '-' to en-
ter the SET THICKNESS.
6 Enter the number of
stitches.
Touch STITCHES and enter the number of stitches. If needed,
the stitch pitch can be changed. See "STITCH PITCH,"
Button
overview
on page 33
7 Enter the spine form
setting
The spine form setting is automatic, according to the SET
THICKNESS setting. If needed, the setting can be changed.
See "FORM" in
Button overview
on page 33
8 Enter the trim setting. The trim setting is automatic, according to the PAGE SIZE
and SET THICKNESS settings. To change the setting, touch
TRIM. See “TRIM” in
Button overview
on page 35
9 Touch CLOSE
If needed, save the job
settings to memory.
If the same job settings are used frequently, then save the job
settings to memory.
See
Load and Save the Job Settings
on page 42.
Procedure for a New Job
22
Chapter 3 - How to run the Booklet maker
To Next Page
Loading...