Step Action Information
4 Check the trim stop and remove any
pieces of trimmed paper.
In particular, check around the sensor.
The sensor is where you can see a red
and a green light (see illustration 'Loca-
tion of the sensor').
Small pieces of paper trimmings can
cover the sensor and cause an error
message.
5 Close the trim stop guard. Push the trim stop guard into position.
Hold the locking plates in position and
tighten the orange hand screws.
6 Attach the trim bin.
Jam in the Trim Area
94
Chapter 6 - Error Conditions, Problems and Solutions
To Next Page
Loading...