SECTION 27 - REAR AXLE 45
Assembly
Collect the belleville washers (23) and (28).
Position the swivel housing (14) on a flat surface
and extract the seal ring (22) with a lever.
NOTE: this is a destructive operation for the seal
ring.
Turn the swivel housing and take the bush (26) out,
using a suitable drift and a hammer.
If it has been previously removed, reassemble the
steering stop composed by the screw (21) and nut
(20).
NOTE: do not tighten the nut (20) until the steering
angle adjustment has been done.
Force the bush (26) into the swivel housing (14) us-
ing the special tool 380002668 and a hammer.
Insert the seal ring (22) into the swivel housing (14)
with the special tool 380002669 and a hammer.
Grease carefully the seal ring (22).
F28046
23
28
F27259
22
2314
F27260
20
21
F28047
14
26
22
To Next Page
Loading...
